DeWalt DCN692N 18v XR Li-Ion Brushless Framing Nailer Bare Unit
Tough, productive and easy to use - with the power to drive a 90mm ring shank nail temperatures as low as -15°. This nail gun is able to fire a 90mm ring shank nail into softwood and 63mm into hardwoods. A combination of intelligent electronics & the DEWALT BRUSHLESS motor means that even the heaviest user should complete a full days work with a single battery change. Unique Bump Mode function of the DEWALT nail gun allows the user to fire 2 nails per second. Battery pack below the handle creates a well-balanced unit that fits easily between 400mm centre studs.
Features and Benefits:
- Two speeds
- Longer run time
- Quicker readiness to fire
- Less recoil
- Able to fire a 90mm Ring Shank nail in Soft Wood and 63mm into Hard Woods
- Sequential operating mode allows for precision placement
- Bump operating mode provides the user with production speed
- Mechanical rather than gas operation offers consistent performance at temperatures between -20 and 50 degrees
- Will accept most clipped head, and off centre, round head paper tape or wire weld collated framing nails
- Reversible belt/rafter hook provides increased portability
- Depths can be easily adjusted using the thumb wheel depth adjuster
- Ergonomic tool design
- Tool-free stall/jam clearance minimises user downtime
- Cordless
- User can engage contact trip lock-off and prevent accidental discharge of the fastener
- Dry fire lockout ensures that the tool is protected from firing without nails in the magazine
Technical Specifications:
Battery chemistry - XR Li-Ion
Voltage - 18v
Nail Diameter - 2.8 - 3.3 mm
Magazine angle - 30 - 34°
Magazine loading - Rear load
Nail Length - 50 - 90 mm
Magazine capacity - Up to 55 Nails
Firing mode - Bump & Sequential
Length - 345mm
Width - 125mm
Height - 338mm
Weight - 4.1kg
Nailer Operating Mode - Selective
Integrated Belt Hook - Yes
Jam Clearing - Yes
Impact energy - 105J
Temperature Range - -20 to 50°C
Fault indicator - Yes